Uranium–thorium dating

From Wikipedia, the free encyclopedia
  (Redirected from Uranium-thorium dating)

Uranium–thorium dating, also called thorium-230 dating, uranium-series disequilibrium dating or uranium-series dating, is a radiometric dating technique established in the 1960s which has been used since the 1970s to determine the age of calcium carbonate materials such as speleothem or coral.[1][better source needed] Unlike other commonly used radiometric dating techniques such as rubidium–strontium or uranium–lead dating, the uranium-thorium technique does not measure accumulation of a stable end-member decay product. Instead, it calculates an age from the degree to which secular equilibrium has been restored between the radioactive isotope thorium-230 and its radioactive parent uranium-234 within a sample.[citation needed]

Background

Uranium and Thorium activity ratios vs time. Q'/P' = 234U/238U, R'/Q' = 230Th/234U

Thorium is not soluble in natural water under conditions found at or near the surface of the earth, so materials grown in or from this water do not usually contain thorium.[citation needed] In contrast, uranium is soluble to some extent in all natural water, so any material that precipitates or is grown from such water also contains trace uranium, typically at levels of between a few parts per billion and few parts per million by weight. As time passes after such material has formed, uranium-234 in the sample with a half-life of 245,000 years decays to thorium-230.[citation needed] Thorium-230 is itself radioactive with a half-life of 75,000 years, so instead of accumulating indefinitely (as for instance is the case for the uranium–lead system), thorium-230 instead approaches secular equilibrium with its radioactive parent uranium-234. At secular equilibrium, the number of thorium-230 decays per year within a sample is equal to the number of thorium-230 produced, which also equals the number of uranium-234 decays per year in the same sample.[citation needed]

History

In 1908, John Joly, a professor of geology from the University of Dublin, found higher Radium contents in deep sediments than in those of the continental shelf, and suspected that detrital sediments scavenged Radium out of sea water. Piggot and Urry found in 1942, that Radium excess corresponded with an excess of Thorium. It took another 20 years until the technique was applied to terrestrial carbonates (speleothems and travertines). In the late 80's the method was refined by mass spectrometry. After Viktor Viktorovich Cherdyntsev's landmark book about uranium-234 had been translated into English, U-Th dating came to widespread research attention in Western geology.[2]:7(subscription required)

Methods

U-series dating is a family of methods which can be applied to different materials over different time ranges. Each method is named after the isotopes measured to obtain the date, mostly a daughter and its parent. Eight methods are listed in the table below.

U-series dating methods[2]
Isotope ratio measured Analytical method Time range (ka) Materials
230Th/234U Alpha spec.mass spec. 1-350 Carbonates, phosphates, organic matter
231Pa/235U Alpha spec. 1-300 Carbonates, phosphates
234U/238U Alpha spec.mass spec. 100-1,000 Carbonates, phosphates
U-trend Alpha spec. 10-1,000(?) Detrital sediment
226Ra Alpha spec. 0.5-10 Carbonates
230Th/232Th Alpha spec. 5-300 Marinesediment
231Pa/230Th Alpha spec. 5-300 Marinesediment
4He/U mass spec. (gas) 20-400(?) Coral

Dating limits

Uranium–thorium dating has an upper age limit of somewhat over 500,000 years, defined by the half-life of thorium-230, the precision with which one can measure the thorium-230/uranium-234 ratio in a sample, and the accuracy to which one know the half-lives of thorium-230 and uranium-234. Using this technique to calculate an age, the ratio of uranium-234 to its parent isotope uranium-238 must also be measured.[citation needed]

Precision

U-Th dating yields most accurate results if applied to precipitated calcium carbonate, that is in stalagmites, travertines, and lacustrine limestones. Bone and shell are less reliable. Mass spectrometry can achieve a precision of ±1%. Conventional alpha counting¨s precision is ±5%. Mass spectrometry also uses smaller samples.[3]

See also

References

  1. ^ Davis, Owen (Spring 2005). "Uranium-Thorium Dating". Biogeography ECOLOGY 438/538. Department of Geosciences, University of Arizona. Retrieved 24 October 2015. 
  2. ^ a b Schwarcz, Henry P. (January 1989). "Uranium series dating of Quaternary deposits". Quaternary International. 1: 7–17. doi:10.1016/1040-6182(89)90005-0. 
  3. ^ Henry P. Schwarcz. Uranium series dating in paleoanthropology. 1992.DOI: 10.1002/evan.13600102071992

External links

  • Shakhashiri, Bassam Z. "Uranium". Chemical of the Week on scifun.org. University of Wisconsin-Madison Chemistry Department. Retrieved 24 October 2015. 
Retrieved from "https://en.wikipedia.org/w/index.php?title=Uranium–thorium_dating&oldid=837998803"
This content was retrieved from Wikipedia : http://en.wikipedia.org/wiki/Uranium-thorium_dating
This page is based on the copyrighted Wikipedia article "Uranium–thorium dating"; it is used under the Creative Commons Attribution-ShareAlike 3.0 Unported License (CC-BY-SA). You may redistribute it, verbatim or modified, providing that you comply with the terms of the CC-BY-SA