sRGB
sRGB (standard Red Green Blue) is an RGB color space created cooperatively by HP and Microsoft in 1996 for use on monitors, printers and the Internet, and subsequently standardized by the IEC as IEC 6196621:1999.^{[1]} It is often used as the "default" color space for images that do not contain any color space information, especially if the images are stored as 8bit integers.
sRGB uses the ITUR BT.709 primaries, the same as are used in studio monitors and HDTV,^{[2]} a transfer function (gamma curve) typical of CRTs, and a viewing environment designed to match typical home and office viewing conditions. This specification allowed sRGB to be directly displayed on typical CRT monitors of the time, a factor which greatly aided its acceptance.
Contents
The sRGB gamut
Chromaticity  Red  Green  Blue  White point 

x  0.6400  0.3000  0.1500  0.3127 
y  0.3300  0.6000  0.0600  0.3290 
Y  0.2126  0.7152  0.0722  1.0000 
sRGB defines the chromaticities of the red, green, and blue primaries, the colors where one of the three channels is nonzero and the other two are zero. The gamut of chromaticities that can be represented in sRGB is the color triangle defined by these primaries. As with any RGB color space, for nonnegative values of R, G, and B it is not possible to represent colors outside this triangle, which is well inside the range of colors visible to a human with normal trichromatic vision.
sRGB is sometimes avoided by highend print publishing professionals because its color gamut is not big enough, especially in the bluegreen colors, to include all the colors that can be reproduced in CMYK printing.
The sRGB transfer function ("gamma")
sRGB also defines a nonlinear transformation between the intensity of these primaries and the actual number stored. The curve is similar to the gamma response of a CRT display. This nonlinear conversion means that sRGB is a reasonably efficient use of the values in an integerbased image file to display humandiscernible light levels.
Unlike most other RGB color spaces, the sRGB gamma cannot be expressed as a single numerical value. The overall gamma is approximately 2.2, consisting of a linear (gamma 1.0) section near black, and a nonlinear section elsewhere involving a 2.4 exponent and a gamma (slope of log output versus log input) changing from 1.0 through about 2.3. The purpose of the linear section is so the curve does not have an infinite slope at zero, it is not for matching CRT behavior.
Specification of the transformation
The forward transformation (CIE XYZ to sRGB)
The CIE XYZ values must be scaled so that the Y of D65 ("white") is 1.0 (X,Y,Z = 0.9505, 1.0000, 1.0890). This is usually true but some color spaces use 100 or other values (such as in the Lab article).
The first step in the calculation of sRGB from CIE XYZ is a linear transformation, which may be carried out by a matrix multiplication. (The numerical values below match those in the official sRGB specification^{[1]}^{[3]} which corrected some small rounding errors in the original publication^{[4]} by sRGB's creators, and assume the 2° standard colorimetric observer for CIE XYZ^{[4]})
It is important to note that these linear RGB values are not the final result as they have not been adjusted for the gamma correction yet. The following formula transforms the linear values into sRGB:
 where and where is , , or .
These gammacorrected values are in the range 0 to 1. If values in the range 0 to 255 are required, e.g. for video display or 8bit graphics, the usual technique is to multiply by 255 and round to an integer.
The values are usually clipped to the 0 to 1 range. This clipping can be done before or after the gamma calculation, or done as part of converting to 8 bits.
The reverse transformation
Again the sRGB component values , , are in the range 0 to 1. (A range of 0 to 255 can simply be divided by 255.0).
 where and where is , , or .
Followed by a matrix multiplication of the linear values to get XYZ:
Theory of the transformation
It is often casually stated that the decoding gamma for sRGB data is 2.2, yet the above transform shows an exponent of 2.4. This is because the net effect of the piecewise decomposition is necessarily a changing instantaneous gamma at each point in the range: it goes from gamma = 1 at zero to a gamma of 2.4 at maximum intensity with a median value being close to 2.2. The transformation was designed to approximate a gamma of about 2.2, but with a linear portion near zero to avoid having an infinite slope at K = 0, which can cause numerical problems. The continuity condition for the curve which is defined above as a piecewise function of , is
Solving with and the standard value yields two solutions, ≈ or ≈ . The IEC 6196621 standard uses the rounded value . However, if we impose the condition that the slopes match as well then we must have
We now have two equations. If we take the two unknowns to be and then we can solve to give
Substituting and gives ≈ and ≈ , with the corresponding lineardomain threshold at ≈ . These values, rounded to , , and , are sometimes used to describe sRGB conversion.^{[5]} Publications by sRGB's creators^{[4]} rounded to and , resulting in a small discontinuity in the curve. Some authors adopted these values in spite of the discontinuity.^{[6]} For the standard, the rounded value was kept and the value was recomputed to make the resulting curve continuous, as described above, resulting in a slope discontinuity from 12.92 below the intersection to 12.70 above.
Viewing environment
Parameter  Value 

Screen luminance level  80 cd/m^{2} 
Illuminant white point  x = 0.3127, y = 0.3290 (D65) 
Image surround reflectance  20% (~medium gray) 
Encoding ambient illuminance level  64 lux 
Encoding ambient white point  x = 0.3457, y = 0.3585 (D50) 
Encoding viewing flare  1.0% 
Typical ambient illuminance level  200 lux 
Typical ambient white point  x = 0.3457, y = 0.3585 (D50) 
Typical viewing flare  5.0% 
The sRGB specification assumes a dimly lit encoding (creation) environment with an ambient correlated color temperature (CCT) of 5000 K. It is interesting to note that this differs from the CCT of the illuminant (D65). Using D50 for both would have made the white point of most photographic paper appear excessively blue.^{[7]} The other parameters, such as the luminance level, are representative of a typical CRT monitor.
For optimal results, the ICC recommends using the encoding viewing environment (i.e., dim, diffuse lighting) rather than the lessstringent typical viewing environment.^{[4]}
Usage
This section needs additional citations for verification. (July 2010) (Learn how and when to remove this template message)

Due to the standardization of sRGB on the Internet, on computers, and on printers, many low to mediumend consumer digital cameras and scanners use sRGB as the default (or only available) working color space. As the sRGB gamut meets or exceeds the gamut of a lowend inkjet printer, an sRGB image is often regarded as satisfactory for home use. However, consumerlevel CCDs are typically uncalibrated, meaning that even though the image is being labeled as sRGB, one can't conclude that the image is coloraccurate sRGB.
If the color space of an image is unknown and it is an 8 to 16bit image format, assuming it is in the sRGB color space is a safe choice. This allows a program to identify a color space for all images, which may be much easier and more reliable than trying to track the "unknown" color space. An ICC profile may be used; the ICC distributes three such profiles:^{[8]} two profiles conforming to version 4 of the ICC specification, which they recommend, and one profile conforming to version 2, which is still commonly used.
Images intended for professional printing via a fully colormanaged workflow, e.g. prepress output, sometimes use another color space such as Adobe RGB (1998), which allows for a wider gamut. If such images are to be used on the Internet they may be converted to sRGB using color management tools that are usually included with software that works in these other color spaces.
The two dominant programming interfaces for 3D graphics, OpenGL and Direct3D, have both incorporated support for the sRGB gamma curve. OpenGL supports textures with sRGB gamma encoded color components (first introduced with EXT_texture_sRGB extension, added to the core in OpenGL 2.1) and rendering into sRGB gamma encoded framebuffers (first introduced with EXT_framebuffer_sRGB extension, added to the core in OpenGL 3.0). Direct3D supports sRGB gamma textures and rendering into sRGB gamma surfaces starting with DirectX 9. Correct mipmapping and interpolation of sRGB gamma textures has direct hardware support in texturing units of most modern GPUs (for example nVidia GeForce 8 performs conversion from 8bit texture to linear values before interpolating those values), and does not have any performance penalty.^{[9]}
See also
References
 ^ ^{a} ^{b} "IEC 6196621:1999". IEC Webstore. International Electrotechnical Commission. Retrieved 3 March 2017.
 ^ Charles A. Poynton (2003). Digital Video and HDTV: Algorithms and Interfaces. Morgan Kaufmann. ISBN 1558607927.
 ^ "How to interpret the sRGB color space" (PDF). color.org. Retrieved 17 October 2017.
 ^ ^{a} ^{b} ^{c} ^{d} Michael Stokes; Matthew Anderson; Srinivasan Chandrasekar; Ricardo Motta (November 5, 1996). "A Standard Default Color Space for the Internet – sRGB, Version 1.10".
 ^ Phil Green & Lindsay W. MacDonald (2002). Colour Engineering: Achieving Device Independent Colour. John Wiley and Sons. ISBN 0471486884.
 ^ Jon Y. Hardeberg (2001). Acquisition and Reproduction of Color Images: Colorimetric and Multispectral Approaches. UniversalPublishers.com. ISBN 1581121350.

^ Rodney, Andrew (2005). Color Management for Photographers. Focal Press. p. 121. ISBN 9780240806495.
Why Calibrate Monitor to D65 When Light Booth is D50
 ^ sRGB profiles, ICC
 ^ "GPU Gems 3: Chapter 24. The Importance of Being Linear, section 24.4.1". NVIDIA Corporation. Retrieved 3 March 2017.
Standards
 IEC 6196621:1999 is the official specification of sRGB. It provides viewing environment, encoding, and colorimetric details.
 Amendment A1:2003 to IEC 6196621:1999 describes an analogous sYCC encoding for YCbCr color spaces, an extendedgamut RGB encoding, and a CIELAB transformation.
 sRGB on www.color.org
 The fourth working draft of IEC 6196621 is available online, but is not the complete standard. It can be downloaded from www2.units.it.
External links
 International Color Consortium
 Archive copy of http://www.srgb.com, now unavailable, containing much information on the design, principles and use of sRGB
 A Standard Default Color Space for the Internet – sRGB at w3.org
 OpenGL extension for sRGB gamma textures at sgi.com
 Conversion matrices for RGB vs. XYZ conversion
 Will the Real sRGB Profile Please Stand Up?