AeroCube 3

From Wikipedia, the free encyclopedia
Jump to navigation Jump to search
AeroCube 3
Mission type Technology
Operator The Aerospace Corporation
COSPAR ID 2009-028E
SATCAT no. 35005
Spacecraft properties
Spacecraft type CubeSat (1U)
Launch mass 1 kilogram (2.2 lb)
Start of mission
Launch date 19 May 2009, 23:55 (2009-05-19UTC23:55Z) UTC
Rocket Minotaur I
Launch site MARS LP-0B
Contractor Orbital Sciences
End of mission
Decay date 6 January 2011
Orbital parameters
Reference system Geocentric
Regime Low Earth
Perigee 427 kilometers (265 mi)
Apogee 465 kilometers (289 mi)
Inclination 40.4 degrees
Period 93.51 minutes
Epoch 22 May 2009[1]

AeroCube 3 is a single-unit CubeSat which was built and is being operated by The Aerospace Corporation. It is the third AeroCube satellite, following on from AeroCube 1, which was lost in a launch failure in 2006, and AeroCube 2 which was successfully launched in 2007 but failed immediately after launch. Compared to its predecessors it contains several improvements in its infrastructure, including a redesigned power system, replacing the older system which was responsible for the loss of AeroCube 2. Its development was funded by the United States Air Force Space and Missile Systems Center.

AeroCube 3 carried technology development experiments. The primary systems demonstrated were a two-axis solar tracker and an Earth tracker, which could be used in the guidance systems of future satellites. It also carried a 0.6-meter (2 ft 0 in) balloon used for tracking tests and to increase drag, increasing the satellite's rate of orbital decay after its mission was completed.

After launch, AeroCube-3 will remain attached to the upper stage of its carrier rocket by means of a 61-meter (200 ft) tether. Experiments will be conducted to determine the satellite's flight dynamics. A wide-angle camera will be used to image the upper stage. The satellite will also reel in the tether, moving closer to the upper stage.

Once the tethered experiments are complete, the tether will be cut, and the spacecraft will begin free-flying experiments. It will align itself with the Earth's magnetic field by means of magnets and hysteresis systems. It carries a number of sensors which will be used to record information pertaining to the surface of the Earth, which will be returned using a store and dump communications system.

It was successfully launched on an Orbital Sciences Corporation Minotaur I rocket from Pad 0B at the Mid-Atlantic Regional Spaceport, at 23:55 GMT on 19 May. It was a tertiary payload, with TacSat-3 as the primary payload and PharmaSat as the secondary. Two other CubeSats, HawkSat I and CP6, were also launched, and together the three satellites were known as the CubeSat Technology Demonstration mission.

See also


  1. ^ McDowell, Jonathan. "Satellite Catalog". Jonathan's Space Page. Retrieved 3 January 2014.
  • Krebs, Gunter. "AeroCube 1". Gunter's Space Page. Retrieved 2009-05-05.
  • "CubeSats" (PDF). TacSat-3 launch. NASA. Retrieved 2009-05-05.
  • Davis, Robert. "Cubesat Tech Demo P-POD" (PDF). Hawk Institute of Space Sciences. Archived from the original (PDF) on 2008-08-19. Retrieved 2009-05-05.

Retrieved from ""
This content was retrieved from Wikipedia :
This page is based on the copyrighted Wikipedia article "AeroCube 3"; it is used under the Creative Commons Attribution-ShareAlike 3.0 Unported License (CC-BY-SA). You may redistribute it, verbatim or modified, providing that you comply with the terms of the CC-BY-SA